Serial Port Connection; 11 -First Switching-On; 12 -Use Of The Machine - Gaggia CONCETTO Instrucciones De Uso

English
Depending on the current regulations of the Country where
the machine operates, the cable connecting the electric
line has to be pre-set or equipped with an all-pole switch
(with a minimum contact opening of 3 mm), (or with a
plug in accordance with the same regulations).
• The all-pole switch has to be adequate to the machine
power consumption and must be able to intercept every
voltage polarity.
• Check if the electric cables of the system are
proportioned to the machine power consumption.
The connection point (electric plug or all-pole switch) must
be located in an easily reachable place, in order to
disconnect the machine from the electric line in case of
need.
• Connect the cord (B - F. 6) to the electric network.
10.4

Serial port connection

Through the serial port the machine can be connected to the
AUTHORIZED CUSTOMER SERVICE CENTER's equipment, for
checks or programming operations (A - F. 9).
A
F. 9
11 - FIRST SWITCHING-ON
- Fill the hopper (6) with the selected coffee beans blend.
Be sure the coffee does not contain foreign bodies which
could be dangerous for grinders.
- Check if the removable components (12 and 16) are in the
right position and if the door (14) is closed.
If they are not, when the machine is switched-on, the display
will indicate which component is in the wrong position.
- Turn the all-pole switch on "I".
- Switch on the machine through the switch (18);
the message "WARMING UP" will be displayed.
- When the message "READY FOR USE" is displayed :
- Adjust the brew group (26 and 27) to obtain the suitable
height depending on the container used (Pr. 8.4).
- Place one or two containers under the brew group.
- Select the beverage and press the corresponding button.
Although buttons are previously programmed on a
standard base, check your beverage has the selected
features. If not, they must be reprogrammed (Pr. 12.6).
12 - USE OF THE MACHINE
Read carefully this brochure until you get a good
understanding of the machine, before starting to operate
it.
After a long time of machine inactivity, read the previous
paragraph "First switching-on" before re-operating
the machine.
31/120
CONCETTO