Siemens TK 53 Serie Instrucciones De Uso página 27

The LEDs for button
light up.
● Place one cleaning tablet in the duct 13.
● Fill the water tank with lukewarm water,
add descaling agent and dissolve com-
pletely (total liquid 0,5 litres)
or
pour prepared descaling mixture into the
water tank (total liquid 0,5 litres).
● Press the steam button
process begins. Duration approx. 10 min-
utes. The descaling solution flows into the
water tray 18.
J
The LED lights up.
● Place a suitable container (approx.
0,5 litres) under the nozzle 8.
● Set the dial 6 to
process begins. Duration approx. 5 min-
utes. The descaling solution flows into the
container.
I
The LED lights up.
● Empty and reinsert the grounds tray 17.
The steam button LED
● Empty and clean the water tank 11, fill
with fresh water up to the "max" mark and
reinsert.
● Place a suitable container (approx.
0,5 litres) under the nozzle 8.
● Press the steam button
ing process begins. Water flows into the
container.
J
The LED flashes.
● Turn the dial 6 to "O". The cleaning
process begins. Duration approx. 10 min-
utes. Liquid flows into the coffee grounds
tray 17 inside the appliance, then out
through the coffee outlet.
I
The LED lights up.
● Empty, clean and reinsert the trays 17
and 18.
The appliance starts to heat up and is ready
for use once the LEDs for dispensing but-
E F
tons 3 and 4
h H
and "Add water"
h
. The descaling
g h
/ . The descaling
h
lights up.
h
. The clean-
light up.
Important: If the service programme is
interrupted, e.g. due to a power cut, it is
vital that the appliance be rinsed before it is
used again.
The appliance must be ready for use.
â
The and steam button
● Rinse the water tank 11 thoroughly and fill
with fresh water.
● Press the steam button
is rinsed and liquid flows into the tray.
J
The LED lights up.
● Hold a cup under the nozzle 8 and turn
g h
the dial 6 to
/
cup.
J
The LED flashes.
● Turn the dial 6 back to "O".
The appliance rinses and is ready for use
again.
Anti-freeze
In order to avoid damage through cold
during transportation and storage, the appli-
ance must be emptied completely
first.
The appliance must be ready for use.
● Remove, empty, and replace water tank.
● Place a large, narrow container under
nozzle 8.
h
● Press button.
● As soon as the LED
rotary button 6 to
The appliance will release steam for a
while.
● When nozzle 8 stops releasing steam,
turn dial back to "O".
● Turn off the appliance.
h
LEDs flash.
h
. The appliance
. Water runs into the
J
lights up, turn the
g h
/ .
en
23