TECshow SATURN Manual De Usuario página 10

2) Channel mode Setting
1. Press <MENU> to enter EDIT interface
2. Press <UP/DOWN> to choose, then press ENTER
to enter Chnd
3. Press UP/DOWN to choose each chan-
nel.'12CH'/'23CH'
4. Press ENTER to confirm, or press "<MENU> to exit
3) Sound activated show mode Setting
1. Press <MENU> to enter EDIT interface
2. Press <UP/DOWN> to choose, then press ENTER
to enter Shnd
3. Press <UP/DOWN> to choose light's three
shows:Sh1,Sh2,Sh3 (can choose any show mode
which is activated by sound)
4. Press ENTER to confirm, or press <MENU> to exit.
4) Master-slave setting
1. Press <MENU> to enter EDIT interface
2. Press <UP/DOWN> to choose, then press ENTER
to enter SLnd
3. Press <UP/DOWN> to choose Mast/SL1.
4. Press ENTER to confirm, or press <MENU> to exit.
5) DMX Lost Setting
1. Press <MENU> to enter EDIT interface
2. Press <UP/DOWN> to choose, then press ENTER
to enter Lost
3. Press <UP/DOWN> can choose light's 4 scenes:
hold, soun, Auto, blac (can choose any scene mode
to operate )
4. Press ENTER to confirm, or press <MENU> to exit.
6) Sound sensitivity Setting
(before this setting, please Press <MENU> into
<Lost> to select <Soun> and save, fixture should be
in Sound Mode first)
1. Press <MENU> to enter EDIT interface
2. Press <UP/DOWN> to choose, then press ENTER
to enter Sens
3. Press <UP/DOWN>, ENTER to adjust the sound
sensitivity from 0%-99%.
4. Press ENTER to confirm, or press <MENU> to exit.
P. 10
Tecshow Saturn |
English version
7) Pan angle setting
1. Press <MENU> to enter EDIT interface.
2. Press <UP/DOWN> to choose, then press ENTER
to enter Angl
3. Press <UP/DOWN> to choose '630'/'540'
4. Press ENTER to confirm, or press <MENU> to exit.
8) Pan reverse setting
1. Press <MENU> to enter EDIT interface.
2. Press <UP/DOWN> to choose, then press ENTER
to enter Pint
3. Press <UP/DOWN> to choose 'YES'/'NO'
4. Press ENTER to confirm, or press <MENU> to
exit.
9) Tilt reverse setting
1. Press <MENU> to enter EDIT interface.
2. Press <UP/DOWN> to choose, then press ENTER
to enter Tint
3. Press Cto choose 'YES'/'NO'
4. Press ENTER to confirm,or press <MENU> to exit.
10) Pan fine setting
1. Press <MENU> to enter EDIT interface.
2. Press <UP/DOWN> to choose, then press ENTER
to enter Padj
3 Press <UP/DOWN> to choose 'P000-P255"'
4. Press ENTER to confirm,or press <MENU> to exit.
11) TILT fine setting
1. Press <MENU> to enter EDIT interface.
2. Press <UP/DOWN> to choose, then press ENTER
to enter Tadj
3 Press<Up/Down> to choose 'T000-T255"'
4.Press <Enter> to confirm,or press "MENU" to exit.
12) LED back light setting
1. Press <MENU> to enter EDIT interface.
2. Press <UP/DOWN> to choose, then press ENTER
to enter LED
3. Press <UP/DOWN> to choose 'ON'/'OFF'
4. Press ENTER to confirm, or press "MENU" to exit.