Tape Playback; Tape Operations - Aiwa CSD-EL300 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

TAPE PLAYBACK

TAPE OPERATIONS

INSERTING A TAPE
Use Type I (normal) tapes only.
Press the TAPE/REV MODE button (or the TAPE
button on the remote control) and press the OPEN
mark to open the cassette holder.
Insert a tape with the exposed side facing forward. Push the
cassette holder to close.
To select a reverse mode
Each time the TAPE/REV MODE (TAPE) button is pressed,
the reverse mode changes.
To play one side only, select P.
To play from front side to back side once only, select
To play both sides repeatedly, select ].
PLAYING BACK A TAPE
Insert a tape.
Press the d button (or the c button on the
remote control) to start play.
x: The side facing upward is being played (forward).
c: The opposite side is being played (reverse).
To stop play, press the s button.
To pause play, press the a button. To resume play, press
again.
To change the playback side, press the d button in play
mode.
To fast forward or rewind, press the f or g button in
stop mode. Then press the s button to stop the tape.
To start play when the power is off (Direct Play Function)
Press the TAPE/REV MODE (TAPE) button. The power is
turned on and play of the inserted tape begins.
To set the tape counter to 0000
Press the s button in stop mode.
The counter is also set to 0000 when the cassette holder is
opened.
About cassette tapes
• To prevent accidental erasure, break off the plastic
tabs on the cassette tape with a screwdriver or other
pointed tool after recording.
Side A
To record on the tape again, cover the tab openings
with adhesive tape, etc.
• 120-minute or longer tapes are extremely thin and
easily deformed or damaged. They are not
.
recommended.
• Take up any slack in the tape with a pencil or similar
tool before use. Slack tape may break or jam in the
mechanism.
Playback side of the tape
Tape counter
Tab for
side A
ENGLISH
En
E
F
7

Publicidad

Tabla de contenido
loading

Tabla de contenido