Jonsered CS16i Manual Del Usuario página 7

• Make sure that you are always in control of the
product.
• The product must be operated with two hands. Do
not operate the product with one hand. Serious injury
to the operator, workers, bystanders, or a
combination of these persons can result from
operation with only one hand.
• Hold the front handle with your left hand and the rear
handle with your right hand. Hold the product on the
right side of your body.
• Do not operate the product when you are tired, ill or
under the influence of alcohol or other drugs.
• Do not use the product if you cannot receive aid if an
accident occurs. Tell others before you operate or
start the product.
• Do not turn with the product before you make sure
that no persons or animals are in the safety area.
• Remove all unwanted materials from the work area
before you start. If the chain hits an object, the object
can eject and cause injury or damage. Unwanted
material can wind around the chain and cause
damage.
• Do not use the product in bad weather, such as fog,
rain, strong winds, risk of lightning or other weather
conditions. Dangerous conditions, such as slippery
surfaces, can occur because of bad weather.
• Make sure that you can move freely and work in a
stable position.
• Make sure that you cannot fall when you use the
product. Do not tilt when you operate the product.
• Stop the motor before you move the product.
• Do not put down the product with the motor on.
• Before you remove unwanted materials from the
product, stop the motor. Let the chain stop before
you remove the cut material.
• Do not operate this product in a tree. Operation of
the product while up in a tree may result in injury.
404 - 002 - 17.11.2017
• Obey all safety instructions to help prevent kickback,
skating, bouncing, and dropping, which can result in
serious injury.
• Adjust the saw chain tension regularly to make sure
that the saw chain has the correct tension. A saw
chain without the correct tension can jump off and
cause serious injury or death.
• Do not fell trees using an incorrect procedure. This
can cause injury to persons, hit a utility line or cause
damage to property.
• The operator must stay on the uphill side of the
terrain as the tree is likely to roll or slide downhill
after it is felled.
• Plan and clear an escape path before cuts are
started. The escape path must extend back and
diagonally behind the possible line of fall.
• Always stop the motor before you move the product
between the trees.
• Make sure you correctly plant your feet on the
ground and apply your weight equally.
7