Conducting Automatic Storing And Printing - Olympus S-DVD-100 Manual Del Usuario

mode
5
Set the Dock&Done mode/PC mode switch to "QDOCK."
DOCK
Notes
• When connecting to the PC, make sure that the power of the unit is off. Then set the Dock&Done/PC mode switch
as follows.
A Remove the disk.
B Perform the PC hardware removal procedure. (g page 37)
C Turn off the unit.
D Set the Dock&Done mode/PC mode switch to "QDock."
• While the unit is processing in PC mode, do not change the setting of the Dock&Done/PC mode switch. This may
cause data loss while recording from your PC to the unit, or a system error on your PC rendering it inoperable. In
this case, shut down your PC, power off the unit, and restart your PC and then the unit.

Conducting automatic storing and printing

For details on usable disks and features, refer to "Types of disks to store data and use with this unit" (g
page 20).
1
Turn the power switch on.
Check that the power indicator (green) and the
2
To automatically store image files, insert a disk into the unit.
Use a disk formatted by the unit, a disk formatted to UDF1.5 format using B's CLiP6 software, or a
blank disk.
Note
We recommended using a blank DVD+RW, or DVD-RW disk for auto storing.
EN-24
PC
I O
Q
DOCK-side indicator (green) are illuminated.
POWER
Turn the printer on in
advance.