About The Back Up - Olympus S-DVD-100 Manual Del Usuario

PC mode (available only when a PC is connected)
2
Click the [Eject Hardware] icon on the system tray.
Select and click the device you want to remove from the list.
3
Click [OK] when the message [Safe to Remove Hardware] is displayed.
When one or more devices are connected to the PC via the unit, follow steps 2 and 3 to remove the
devices.
Note
Before disconnecting the unit from a PC, check there is no message on the PC screen like below.
- Image data is being loaded.
- An application has launched, opening image files.
You cannot disconnect an unit from a PC, when the message "Cannot stop xxxx" is displayed on the PC screen.
4
Turn off the power switch of the unit.

About the Back up

As important data can be lost due to erroneous operation, unexpected breakdown or disk degradation, always
back up your data.
Backup of data stored to disk can be accomplished using OLYMPUS Master software. For details on back up,
refer to the help and the on-line manual of the OLYMPUS Master software.
EN-38