Safety regulations
CAUTION
Do not block heat radiation
Do not place the device in a poorly ventilated environment or on a soft surface such as a
rug or bed.
Do not place the device on an unstable surface
Do not place the device on an unstable surface, such as a wobbly or uneven table. If the
device falls or topples, it may cause injury and/or become faulty.
Do not touch the non-user-serviceable parts inside the device
Doing so may cause injury or a burn. Be careful that young children and/or persons who
are unfamiliar with electrical equipment do not touch the inside of the device.
Do not unplug the power cord while holding the cord instead
of the plug
To unplug the power cord, hold the plug. Pulling the cord directly may damage it,
possibly resulting in a fire or electric shock.
Before cleaning the device, disconnect the power cord
When cleaning the device, make sure that the power cord is disconnected from an
outlet.
Unplug the device if it will not be used for an extended period
of time
Unplug the device from the outlet if it will not be used for an extended period of time
because of a long trip or similar event.
Otherwise, deteriorated insulation or current leakage may cause a fire or electric shock.
Do not charge the battery for an extended period of time (no
more than 24 hours at one time)
Remove the digital camera on the storage unit once battery charging is complete.
Otherwise, charging an extended period of time may cause fire.
Provide correct voltage
Incorrect voltage may damage device parts.
Use in this condition may cause fire or electric shock.
EN-10