Olympus S-HD-100 Manual Del Usuario página 29

Dock&Done mode
Problem
The Dock&Done The unit is not turned on.
menu does not
appear on the digital
The digital camera is not properly
camera after
connected to the unit.
connecting to the
The unit is in PC mode.
unit.
"STORING Newly taken image file is not in the digital
ONLY" cannot be camera.
selected from the
Dock&Done menu
on the digital
camera.
"STORE:PRINT" Print order information is not set.
cannot be selected
from the
Dock&Done menu
on the digital
The printer is not connected, or the power
camera.
of the printer is not on.
"STORE:SEL. The printer is not connected, or the power
PRINT" cannot be of the printer is not on.
selected from the
Dock&Done menu
on the digital
camera.
An image file Not enough hard disk space is available.
cannot be stored.
The image file was taken by a
Dock&Done-incompatible digital camera,
and then stored by a Dock&Done-
compatible digital camera.
Cause/Status
Troubleshooting
Solution
Turn on the power to the unit and make
sure that the power indicator turns on.
Turn the unit off, then back on before
connecting the digital camera.
Set the Dock&Done mode/PC mode
switch to the Dock&Done mode and
make sure that the Dock&Done mode
indicator turns on.
After taking new pictures, set the
digital camera back on the cradle.
Check to see if a print order
information has been set. If not, set the
print order information and connect the
digital camera to the unit again.
Check to see if the printer is properly
connected and turned on.
Check to see if the printer is properly
connected and turned on.
Back up image files on the unit and
then use OLYMPUS Master software
to delete the image files.
Image data taken by a Dock&Done-
incompatible digital camera may not
be storable on the storage unit. For
details about changing the storing
mode, refer to the reference manual
supplied with the digital camera.
EN-29