Toshiba MMU-AP0071MH Manual Del Propietário página 15

Under Ceiling Type
• While the air conditioner is not in operation, the horizontal flap (Up/Down air direction
adjustment plate) will automatically point upwards.
• When the air conditioner is in ready status for heating, the horizontal flap (Up/Down air
direction adjustment plate) will points upwards. The swinging operation will begin after the
heating ready status has been cleared. Please note the "SWING
displayed on the remote controller even when the status is ready to heat.
How to adjust the air flow direction
SWING/FIX
Push button during operation.
the
In Heating operation
Set the horizontal flap (Up/Down
air direction adjustment plate)
downwards. If the air flow is directed
upwards, the hot air may not reach
the floor, creating an uneven
temperature within the room.
How to adjust the air flow direction, using
the swinging function
2
SWING/FIX
Push the button.
Set the direction of the horizontal flap (Up/
Down air direction adjustment plate) to its
lowest position and then push the
button again.
• [SWING ] is displayed and the air direction will
automatically upwards or downwards.
In cases where one remote controller controls
multiple indoor units, it is possible to set each
indoor unit individually, so that the air flow direc-
tion can be altered.
How to stop the louver from swinging
3
SWING/FIX
Push the button again while the hori-
zontal flap is moving
• The horizontal flap can be stopped at any position
desired. If you wish to return the louvre to it original
upwards position, press the
* During the cooling/drying operation the horizon-
tal flap will not stop at its most downwards
facing position 9 (reduce the risk of water
dripping), but will instead move to the 3rd
position from the top (as shown in the figure).
4
UNIT
• To set up the air flow direction individually, push
UNIT
the button to display each indoor unit No. in
a group control. You can then set the air flow
direction for the displayed indoor unit.
• If there is no display, all the indoor units can be
operated collectively.
• For every push of the
will alter between units as shown in the figure.
No display
Unit No. 1-4
Initial setup
SWING/FIX
SWING/FIX
button again.
UNIT
button, the display
Unit No. 1-1 Unit No. 1-2
Unit No. 1-3
1
Every time you push the button the air
flow direction will change.
In Cooling / Dry operation
Set the horizontal flap (Up/Down
air direction adjustment plate)
upwards. If directing the air flow
downwards, condensation may
form on the surface of the louver
and may cause water to drip.
TEMP.
FILTER
RESET TEST
1, 2, 3
In FAN operation
Initial setup
Display when stopping the swing
Fan/Heat
operation
12
" symbol will still be
Initial setup
ON / OFF
TIMER SET FAN MODE
TIME SWING/FIX VENT
SET CL UNIT
4
In all modes
Series of
operation
Cool/Dry
operation