Rowenta DW13 Instrucciones De Seguridad página 32

If there is a problem?
PROBLEM
Water drips from
the holes in the
soleplate.
Brown streaks
come through
the holes in the
soleplate and
stain the linen.
Your soleplate
emits particles.
The soleplate is
dirty or brown
and can stain
the linen.
There is little or
no steam.
The soleplate
is scratched or
damaged.
Steam or water
come from the
iron as you finish
filling the tank.
The spray does
not spray.
32
POSSIBLE CAUSE
You are using steam while the
iron is not hot enough.
You are using the shot of steam
button too often.
You have stored the iron
horizontally, without emptying it
and without setting it to
You are using ironing water
additives (i.e. scented water,
starch).
You are not using the right type
of water.
Your linen has not been rinsed
sufficiently or you have ironed
a new garment before washing
it.
Limescale is starting to build up
on your soleplate.
Your are ironing with an
inappropriate temperature
selection (temperature too high).
You have ironed over a printed
are of a garment.
The water tank is empty.
Your iron has been used dry for
too long.
You have placed your iron
flat on a metallic rest-plate or
ironed over a zip.
The steam control is not set to
the position.
The water tank is overfilled.
The water tank is not filled
enough.
Wait until the thermostat light
goes out.
Wait a few seconds between each
use of the button.
See the section «Storing your
iron».
.
Never use ironing water additives;
these will permanently damage
your steam iron.
Perform a Self cleaning operation
and consult the chapter «What
water should I use?».
Make sure that your laundry is rinsed
sufficiently in order to remove any
deposits of soap or chemical products
on new clothes.
Perform a self-clean.
Clean the soleplate (refer
to chapter 11). Select the
appropriate program.
Never iron over printed areas or
applications – always iron the
reverse side of such a garment.
Fill the water tank.
Carry out a Self clean.
Refrain from ironing over metallic
buttons or zippers.
Check that the steam control is
set to the
Never exceed the Max level.
Fill up the water tank.
SOLUTION
position.