Removing And Refitting The Metal Grease Filter; Cleaning The Metal Mesh Grease Filters; Changing The Activated Charcoal Filter (Only In Circulating-Air Mode); Resetting The Saturation Indicator - Gaggenau VL 200 120 Instrucciones De Uso

Cleaning and maintenance
en
Removing and refitting the metal
grease filter
1 Remove the filter cover.
2 Pull the metal grease filter up and out of the
appliance.
3 Clean the metal grease filter and filter cover.
4 Clean the inside of the downdraft ventilation.
5 Insert the metal grease filter.
6 Put the filter cover on.
12
Cleaning the metal mesh grease
filters
m
Warning – Risk of fire!
Grease deposits in the grease filter may catch fire.
Clean the grease filter at least every 2 months.
Never operate the appliance without the grease filter.
The metal grease filter can be cleaned in the
dishwasher or by hand.
Cleaning in the dishwasher
Note: Slight discolouration may occur if cleaning in the
dishwasher. This has no effect on the performance of
the metal grease filter.
1 Place the metal grease filters loosely in the
dishwasher with the opening facing down. Do not
jam in the metal grease filters.
2 Do not clean heavily soiled metal grease filters
together with tableware.
Cleaning by hand
1 Soak the metal grease filter in hot soapy water.
2 Clean with a brush and then rinse thoroughly.
3 Allow the metal grease filter to dry before inserting.
Note: You can use a special degreaser to remove
stubborn dirt. It can be ordered via the Online Shop.
Changing the activated charcoal filter
(only in circulating-air mode)
Activated charcoal filters trap the odour-causing
compounds in cooking smells. They are only used for
circulating-air mode.
The activated charcoal filter of the remote fan unit must
be replaced at regular intervals. The saturation indicator
on your appliance will tell you how frequently this needs
to be done.

Resetting the saturation indicator

If the saturation indicator for the metal grease filter or
activated charcoal filter has flashed, you must reset the
saturation indicator after cleaning or changing the filter.
1 Push in the control knob and turn it clockwise to the
œ
position.
The saturation indicator is reset. The illuminated
ring behind the control knob will flash 3 times. A
signal tone will sound.
2 Turn the control knob back to position 0.