Recording Conditions Set Setting; Recording Settings For Digital Series Connection (Maximum 3 Units) - Sanyo DSR-3000 Manual De Instrucciones

RECORDING CONDITIONS SET SETTING

This lets you make settings and set overwriting permissions for each recording area when multiple digital video recorders (up to a
maximum of three) are connected for series recording.
Main menu 1
<MAIN MENU 1>
1.LANGUAGE/CLOCK SET ->
2.VIDEO INPUT SET ->
3.RECORDING AREA SET ->
4.RECORDING CONDITIONS SET ->
5.NORMAL REC MODE SET ->
6.TIMER SET ->
7.HOLIDAY SET ->
8.ALARM REC MODE SET ->
TO MAIN MENU 2 ->
MOVE LINES WITH JOG. SELECT WITH SHUTTLE
Recording settings for digital series
connection (maximum 3 units)
1
Connect the digital video recorders using the digital input
and output terminals of each digital video recorder.
(See page 8.)
Note:
•
Use a straight-type STP (shielded twisted pair) Ethernet cable to
connect the digital video recorders. Each cable should not be any
longer than 3 meters.
•
If using alarm input, input the same alarm signal to all digital video
recorders.
2
Press the MENU button to select RECORDING CONDITIONS
SET, and then turn the shuttle dial clockwise.
The RECORDING CONDITIONS SET sub-menu appears, and
the cursor moves DIGITAL SERIES RECORDING.
MENU
3
Turn the shuttle dial clockwise.
"OFF" flashes.
English
Sub-menus
<RECORDING CONDITIONS SET>
DIGITAL SERIES RECORDING : OFF
TOTAL NUMBER : **
RECORDING NUMBER : **
NORMAL RECORDING AREA
OVERWRITE : ON
ALARM RECORDING AREA
OVERWRITE : ON
REMAINING DISK WARNING : **
<RECORDING CONDITIONS SET>
DIGITAL SERIES RECORDING : OFF
TOTAL NUMBER : **
RECORDING NUMBER : **
NORMAL RECORDING AREA
OVERWRITE : ON
ALARM RECORDING AREA
OVERWRITE : ON
REMAINING DISK WARNING : **
<RECORDING CONDITIONS SET>
DIGITAL SERIES RECORDING : OFF
TOTAL NUMBER : **
RECORDING NUMBER : **
47
Sets series recording.
Sets the number of digital video recorders
connected.
Sets the number of units connected.
Sets overwriting for the normal recording
area.
Sets overwriting for the alarm recording
area.
Sets the remaining space warning for the
recording areas.
4
Use the jog dial to change the setting to " ON" , and then turn
the shuttle dial clockwise.
The cursor moves to TOTAL NUMBER.
5
Turn the shuttle dial clockwise, use the jog dial to set the
total number of digital video recorders connected (example:
3), and then turn the shuttle dial clockwise.
The cursor moves to RECORDING NUMBER.
6
Turn the shuttle dial clockwise, use the jog dial to set the
connection number (example: 1), and then turn the shuttle
dial clockwise.
The cursor moves to OVERWRITE.
Note:
•
The digital video recorder which is used as the main unit should
always have its connection number set to 1.
•
Do not skip or overlap numbers when making the settings.
•
If NETWORK CONTROL in the NETWORK SET menu has been
set to "ON", DIGITAL SERIES RECORDING cannot be selected.
Conversely, if DIGITAL SERIES RECORDING has been set to
"ON", NETWORK CONTROL cannot be set to "ON".
•
The VIDEO INPUT SET for VIDEO INPUT of the second and
subsequent digital video recorder must be set to DIGITAL.
<RECORDING CONDITIONS SET>
DIGITAL SERIES RECORDING : ON
TOTAL NUMBER : 2
RECORDING NUMBER : 1
<RECORDING CONDITIONS SET>
DIGITAL SERIES RECORDING : ON
TOTAL NUMBER : 3
RECORDING NUMBER : 1