ALFRA ROTASPEED RS 230 Instrucciones De Manejo página 19

Tool use and care
Keep cutting tool sharp and clean to avoid binding.
Before using the tool check for misalignment, binding or damaged parts.
If damaged parts are observed have the tool serviced immediately.
Check lower guard for proper closing before each use. Do not use saw if lower guard does not
move freely and close instantly. If the guard is not operating properly it must be serviced
before use. Never clamp or tie the lower guard into an open position.
When marking out always use an edge guide to improve the accuracy of the cut.
Always use blade with correct size and shape. Blades that do not match the mounting
hardware of the saw will run eccentrically.
Use only accessories that are recommended by the manufacturer for your model.
19
19