Publicidad
Idiomas disponibles
Idiomas disponibles
Cut out
1. Tilt the saw forward. The blade guide has to lie flat on the workpiece. The saw blade should be just above the
cutting line without touching it. Push the lever (A) forward to lift up the saw blade guard.
2. Turn on the saw and wait until the motor reaches full speed before you start to cut. Use the front of the saw as a
hinge point. Gradually lower the saw into the workpiece to carry out the cut. Loosen the lever (A).
3. Turn off the saw and wait until the blade comes to a complete stop before you remove it from the workpiece.
4. Use a small hand saw to cut out the corners.
Bevel cut
Loosen the lock lever (A) and the wing nut (B) to adjust the blade guard (C) to the required angle from 90° to 45° .
Tighten the lock lever (A) and the wing nut (B) after making adjustments.
24
24
Publicidad
