Publicidad
Idiomas disponibles
Idiomas disponibles
Chip collector
For best performance and to prevent overheating, empty the chip collector regularly.
Before removing chips disconnect the saw from the power source.
1.
Loosen the two chip collector cover thumb screws (A).
A
Fig.22
2.
Remove chip collector cover on the side of the saw.
3.
Empty chip collector by tipping the cover sideways and letting the chips and debris fall out.
Clean all debris from saw body.
Fig.23
4.
Install chip collector cover back on the saw and fasten the thumb screws.
Failure to secure the chip collector cover may result in uncontrolled discharge of chips and
operator injury. Always verify proper installation of the cover and check frequently.
27
27
Publicidad
