Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
1.
Select the correct saw blade appropriate to the material you want to cut. (Mild steel, stainless steel or
aluminum).
Cutting-∅ ∅ ∅ ∅ mm
230/9"
230/9"
230/9"
* With stainless steel the tool life will be lower in relation to the material thickness.
2.
If required assemble edge guide to base plate and adjust it to desired position. Secure it with thumb screw.
3.
The surface of the material must be plane and clean.
4.
Adjust the base plate to the desired angle by loosening the bevel lever lock at front and rear of the saw.
5.
When making long and straight cuts insert the edge guide to the desired width and secure it with the thumb
screws or use the laser guide.
6.
To adjust the cutting depth loosen the rear lever lock. The cutting depth should be adjusted to the maximum
unless there are obstructions below your work piece.
7.
Connect the saw to the power source.
8.
Firmly grasp guide handle and auxiliary handle.
9.
Position saw base plate on work surface near the cutting area.
10. Turn the laser on. Laser switch is found on top of the guide handle.
Note: the laser is not required for saw operation.
11. Start the motor by activating the trigger switch.
12. Slowly approach the edge of the material and gently apply pressure until the saw blade established the cut.
13. After completing the cut release the trigger switch to the "Off" position and turn off the laser.
If the saw motor should stall or stop before a complete cut is made, always remove the blade
from the material before you restart the motor.
Application
Steel / stainless steel*
Aluminum
Trapezoidal sheets
Dimensions mm
No. of teeth
230 x 25.4
48
230 x 25.4
62
230 x 25.4
80
Prod.-No.
22305
22306
22307
21
21
Publicidad
