While Operating Machine - Nobles STRIVE Manual Del Operador

FIG. 6
2. Lower the scrub head by pressing the scrub head
switch (Figure 7).
NOTE: If the machine is set up for ReadySpace
cleaning, a 20 second priming process will
automatically begin spraying solution when the scrub
head is lowered.
FIG. 7
3. To begin cleaning, rotate the control grips forward
and gradually turn the speed control knob to the
recommended cleaning speed (Figure 8).
ReadySpace Cleaning: 30m (100 ft.) per minute.
Restorative Extraction Cleaning: 15m (50 ft.) per
minute.
NOTE: The control grips activate the drive, brushes
and solution flow.
FIG. 8
Nobles Strive (04- -07)
Home Find... Go To..
To operate the machine in reverse, simply rotate
the control grips backwards. The machine will
continue to clean in reverse during ReadySpace
cleaning. This allows you to back clean over
heavily soiled areas, into corners and tight spaces.
When reversing during restorative extraction the
scrub head will raise and the cleaning stops.
4. Adjust the brush pressure meter. For best cleaning
results, adjust the brush pressure meter within the
green zone as shown below (Figure 9).
ATTENTION: Do not operate the machine with the
brush pressure meter in the red zone, circuit
breakers will trip.
For Restorative
Extraction
FIG. 9
5. To stop the machine, position the machine on a
level surface and gradually release the control
grips.
6. After restorative extraction cleaning, place air
movers in the area to reduce the drying time.
7. Perform the DAILY MACHINE MAINTENANCE
procedures.

WHILE OPERATING MACHINE

WARNING: Fire Or Explosion Hazard. Do Not
Pick Up Flammable Materials Or Reactive Metals.
1. Overlap each cleaning path by 50 mm (2 in).
2. Use a collapsing rectangle pattern when cleaning
large rooms (Figure 10).
FIG. 10
OPERATION
For ReadySpace
13