Miele APCL Serie Instrucciones De Montaje página 12

12 von 25
Risk of injury due to excessive physical strain
WARNING
 Risk of injury due to excessive physical strain.
Spinal injuries.
The relation of the weight of the machine to the physical strength of the technician
A
must be taken into account. For machine weight details, see the operating
instructions.
Stand preparation
A
Use two 6 x 12 screws to attach each of the clamping plates to the rear of the stand; see Fig. 1.
The arrow embossed on the top of the stand points to the front; see Fig. 1.
A
Level the stand on the floor.
A
Mark the hole positions.
A
Drill 12mm dia. holes in the marked positions approx. 65mm deep.
A
Insert plugs (5) in the holes; see Fig. 2.
A
Level the stand using the provided washers (4); see Fig. 2.
A
Fasten the stand to the floor using the hex-head wood screws (1), 8.4 washers (2) and 15 x 44 x 3 washers (3); see
Fig. 2.
Installing a washer on the stand
A
Install the clamps on the stand and fasten them in the appropriate holes (1); see Fig. 3.
A
Secure each clamp to the stand with one M6 x 30 bolt (1), two galvanized B6.4 washers (2) and an M6 nut (3). Do not
tighten the nuts yet; see Fig. 4.
A
Unscrew the washing-machine feet by at least 5mm.
A
Place the washing machine on the stand and slide its rear feet into the clamping plates.
A
Level the washing machine on the stand.
A
Use the clamps to secure the washing machine to the front feet; see Fig. 4.
A
Install a second M6 nut (4) on each of the feet to counter the first nut; see Fig. 4.
A
Screw one M6 x 20 screw (1) into each of the clamping plates and tighten; see Fig. 5.
Installing a dryer on the stand
A
Unscrew the dryer feet by at least 5mm.
A
Place the dryer on the stand and slide its rear feet into the clamping plates.
A
Level the dryer on the stand.
A
Screw one M6x20 screw (1) into each of the clamping plates and tighten; see Fig. 6.
Installing the stand panels
A
Use four M4x25 screws to attach each of the two side panels; see Fig. 7.
A
Use four M4x25 screws to attach the front panel; see Fig. 7.
en-US
es
20.01.2020 Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
M.-Nr. 11313351