Tabla de contenido
Publicidad
M.-Nr. 11313351
No.
Mat. no.
Designation
1
Front panel (box plinth only)
2
Side panel (box plinth only)
12
Raised-head screw M4 x 25 (box plinth only)
Danger due to incorrectly carried out service and repair work
WARNING
Danger due to incorrectly carried out service and repair work
There is a risk of serious damage, injury and even death if service and repair work is
carried out incorrectly.
Service and repair work should only be carried out by a suitably qualified electrician
A
with specialist training, knowledge and experience.
All appropriate safety regulations must be taken into account.
A
First read the Technical Service Documentation (TSD), then commence work.
A
Measures to be carried out before commencing any service work
– Carry out appropriate electrical safety checks.
– Disconnect all machine utility connections in accordance with the operating
instructions.
Measures to be carried out after service work has been completed
– Carry out appropriate electrical safety checks.
– Check the appliance for correct operation.
Risk of cuts during service and maintenance work
WARNING
Components may have sharp edges.
There is a risk of cuts during service and maintenance work.
Protective gloves should be worn.
A
Danger of injury due to excess physical strain
WARNING
Danger of injury due to excess physical strain.
Spinal injuries.
The relation of the weight of the machines to the physical strength of the technician
A
must be taken into account. For machine weight details, see the operating
instructions.
Preparing the plinth
A
Use 2 screws (6 x 12) to attach each of the clamping plates to the rear of the plinth, see Fig. 1.
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
9 von 25
20.01.2020
Publicidad
Tabla de contenido
