Guide To The Appliance; Overview; Switching On And Off; Control Leds - Miele professional XKM RS232 10 Med Instrucciones De Montaje

Overview

a
Push button
b
Indicator LED,
Indicates ready-for-use status after installation and active commu-
nication during operation
c
Data plate (located on the side)
d
Data cable

Switching on and off

The module does not have a separate On/Off button. It is switched on
and off in conjunction with the washer-disinfector.

Control LEDs

The control LEDs (light emitting diodes) give status information about
the communication module.
LED
FLASHES
YELLOW
LIT UP
YELLOW
LIT UP
RED
en - Guide to the appliance
Status
The module has connected with the terminal
device and is ready for use.
The module is transmitting data.
The LED lights up red when the the push button
is pressed and the module is correctly installed.
If the LED does not light up when the button is
pressed, either the module is incorrectly installed,
or the washer-disinfector is not switched on, or
the module is faulty.
29