Tabla De Contenido; Symbols Used In This Document; Overview Drawing - Grundfos Unilift AP12 Instrucciones De Instalación Y Funcionamiento

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CONTENTS
1.
2.
3.
4.
5.
6.
7.
8.
8.1
8.2
8.3
8.4
9.
9.1
10.
11.
12.
13.
Warning
Prior to installation, read these
installation and operating instructions.
Installation and operation must comply
with local regulations and accepted
codes of good practice.

1. Symbols used in this document

Warning
If these safety instructions are not
observed, it may result in personal
injury!
If these safety instructions are not
observed, it may result in malfunction
Caution
or damage to the equipment!
Notes or instructions that make the job
Note
easier and ensure safe operation.
4

2. Overview drawing

Page
4
Discharge port
4
4
5
5
6
Pump
sleeve
6
6
6
6
7
7
7
7
8
8
Suction strainer
8
8
Fig. 1
Unilift AP pump
8
9
3. Applications
9
The Grundfos Unilift AP pumps are single-stage,
10
submersible pumps designed for the pumping of
10
wastewater.
The pumps are capable of pumping water containing
a limited quantity of spherical particles up to these
sizes:
Unilift AP12: 0.47" in diameter
Unilift AP35: 1.38" in diameter
Unilift AP50: 1.97" in diameter
Pumping of spherical particles exceeding the above
sizes may block or damage the pump.
The pumps are designed for automatic operation
with float switch and for manual operation. The pump
can be installed in a permanent installation or used
as a portable pump. Incorrect use of the pump, for
example resulting in blockage or wear of the pump,
is not covered by the warranty.
Handle with
clamp
Float switch

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Unilift ap35Unilift ap50

Tabla de contenido