Miele UG 6163 Instrucciones De Montaje página 25

Produktgruppen 512, 592
25 von 26
Note
Use this stand only for the following Miele machines:
PW 6163 (07493360, 07493370)
PW 6243 (07493380, 07493390)
PW 6323 (07493400, 07493410)
Note
Tools required:
Bubble level for stand leveling.
Open wrench, 19 mm, for 12 x 90 mm bolts for floor mounting.
Open wrench, 10 mm, for 6 x 10 mm bolts for floor mounting.
Torx T-20 screwdriver.
Note
This kit contains the following:
2 pre-installed feet
2 pre-installed front panels
2 side panels
12 screws, DM 6 x 12
8 screws, CEM 6 x 16
1 information sheet
These installation instructions
List of illustrations:
Fig. 1, side panel and service panel removal
Fig. 2, floor bracket removal
Fig. 3, foot installation
Fig. 4, front and side panel installation
Disconnect the machine from the steam supply (if applicable) and electric supply, and ensure that utilities cannot be
switched on again in error.
Remove the 2 side panels and 2 service panels, Fig. 1.
Unscrew the machine's floor fastening.
Note
If applicable, remove any spacer plates that may be in use and take care to note the number installed and their
positions so that they can be reinstalled in an identical manner.
Disconnect the floor drain.
Use a suitable lifting aid (e.g., pallet truck and suitable wood blocks) to raise the machine by approximately 200 mm.
Danger!
Take suitable measures to ensure that the machine cannot fall
Unscrew the 4 floor mounting brackets, Fig. 2, Pos. 1.
Install the pre-installed feet (Fig. 4, Pos. 2) on the left and right under the machine base frame and screw them in
position.
(On each corner, 2 screws from the inside and 1 screw from the bottom; see Fig. 4, Pos. 3.)
Warning!
Use the new provided DM 6 x 12 screws for securing the feet to the floor frame.
02.03.2012 Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
M.-Nr. 07564361