Important; Tool Use And Care; Specific Safety Rules - Surtek SK403C Manual De Usuario Y Garantía

Before connecting the tool to a power source
(receptacle, outlet, etc.) be sure that the volt-
age supplied is the same as that one specified
on the nameplate of the tool. To use a not
specified voltage may cause a serious injury to
the user as well as damage the tool.
IMPORTANT: This appliance is not intended
for use by persons (including children) with re-
duced physical, sensory or mental capabilities
may be different or reduced, or lack of experi-
ence or knowledge, unless such persons are su-
pervised or trained to operate the product by
a person responsible for their safety. Children
should be supervised to ensure they do not use
the devices as toys.

TOOL USE AND CARE

Do not force the power tool. Use the correct
tool for the application. The correct tool will
do the job better and more safely at the rate
that it was designed to work at.
Do not use tools if switch does not turn it on
or off. Any tool that cannot be controlled with
the switch is dangerous and must be repaired.
Disconnect the plug from the power source
before making any adjustments, changing ac-
cessories or storing the tool. This preventive
safety measures reduce the risk of accidental
starting of the tool.
When the power tool is not in use, store it out
of the reach of children, and do not allow in-
dividuals who are not familiar with the power
tool or these instructions to operate it. Power
tools are dangerous in the hands on untrained
users.
Maintain the power tool. Check for misalign-
ment or binding of moving parts, broken parts,
and any other condition that may affect the
operation of the power tool. If it is damaged,
have it repaired before using. Many accidents
are caused by poorly maintained power tools.
Check for misalignment or bonding of moving
parts, breakage parts, and any other condition
that may affect the tools operation. If you find
a damaged tool, take it to service before use it.
Use only accessories that are recommended by
the manufacturer of your model. Suitable ac-
cessories for one tool, may become hazardous
when are used on another tool.
8
Keep cutting tools, sharpened and clean. Cut-
ting tools in good condition with sharpened
edges, are less likely to stuck in workpieces or
easier to control.
Is recommendable to use a safety device suit-
able, such a thermal and differential switch
when you are using an electric equipment.
SERVICE
Tool service must be performed only by quali-
fied repair personnel. Service or maintenance
performed by unqualified personnel could re-
sult in a risk of injury.
SPECIFIC SAFETY RULES FOR
PENDULUM JIG SAWS
• When fitting and changing saw blades,
always follow this manual instructions.
• Use clamps or a vice to hold your work if pos-
sible.
• Make sure the switch is off before you plug in.
• Do not overreach, be sure of your footing
and balance at all times specially in ladders
and staging.
• Only use blades in perfect condition.
• Keep the shoe flat on the work piece.
• Do not put under pressure on the saw, such
that in it slows down.
• Always switch off before you put the jig saw
down.
• Disconnect the saw when not using it, before
cleaning and when changing saw blades.
• The unit should only be used as a hand held
tool and must never be foxed on an inverted
position for use as a saw bench unless with an
approved accessory.
DOUBLE INSULATION
Your jig saw is double insulated. This means
that two independent barriers of insulation
protect you from contacting live parts thus giv-
ing further protection against the possibility of
electric shock.