Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
FEATURES
KNOW YOUR TOOL
This tool is electronic speed control pendulum
jig saw. Adjustable speed and 3-stage pendu-
lum action gives you enhanced cutting perfor-
mance and an optimum curve/cutting action
saving your blade from under wear.
3
4
7
5
1. ON/OFF SWITCH
2. LOCK-ON BUTTON
3. VARIABLE SPEED SELECTOR
4. SAFETY GUARD
5. PENDULAR KNOB
6. DUST MANAGEMENT SYSTEM
7. SHOE PLATE
8. GUIDE
OPERATION INSTRUCTIONS
The saw is started by pressing the ON/OFF
switch, the switch can be maintained in the
ope-rating position by using the lock-on but-
ton.
The lock-on button can be released by press
and releasing the ON/OFF switch once more.
ELECTRONIC SPEED REGULATOR
The electronic speed control wheel is used to
program the required saw speed.
In this way, the speed can be adapted to the
material being worked. Turn forward for speed
up, otherwise down. The figure is larger, the
speed is quicker.
2
1
6
8
E N G L I S H •
PENDULUM STROKE ADJUSTMENT
Together with the electronic speed regulation,
the pendulum stroke adjustment helps to set
the best combination of blade speed and ag-
gressiveness needed to achieve a desired cut
rate and fineness.
The pendular knob is used to make the adjust-
ment. The best pendulum stroke setting for
the particular work to be carried out obtained
from the follow table;
NOTE: When using a knife blade, the pendu-
lum setting should be 0. We recommend the
use of appropiate lubricants for cutting metal.
Pendular
Position
Material
Movement
0
No pendular
Rubber, ceramic,
motion
aluminum, steel
1
Low
Plastic, wood,
aluminum
2
Large
Wood
SAW SHOE ADJUSTMENT FOR ANGULAR
CUTTING
Disconnect the unit from the power supply.
Raise the safety guard and loosen the hex
screws on the shoe plate with the hex key tak-
en form its holder.
Pull the shoe plate
backward and set the
desired angular ad-
justment according to
the scale or push the
shoe plate forward
for fixed locks at 0˚,
15˚, 30˚ or 45˚.
Tighten the hex screw again. Always replace
the hex key in the hex key holder of shoe plate
immediately after use.
DUST EXTRACTION
In order to improve dust extraction from the
working surface, the saw has a saw dust blow-
ing system which clears dust from the cutting
line. In addition a vacuum cleaner adapter can
be used to connect an ordinary household vac-
uum cleaner.
U se r' s m a nu a l
Features
For fine/clean cutting
edges, thin materials,
hard material
Hard materials
Soft materials (saw
along the fiber
direction)
9
Publicidad
Tabla de contenido
