Rear Panel Overview - Numark AVMO2 Manual De Inicio Rápido Del Usuario

Quick Setup Guide
1. Make sure all items listed on the front of this guide are included in the box.
2. READ SAFETY INSTRUCTION BOOKLET BEFORE USING THE PRODUCT
3. Study this setup diagram.
4. Place the mixer in an appropriate position for operation.
5. Make sure all devices are turned off and all faders are at their lowest setting.
6. Connect all input sources as indicated in the diagram.
7. Connect the outputs to the power amplifier(s), monitors and/or projectors.
8. Plug your mixer and other devices into AC power.
9. Switch everything on in the following order:
Audio input sources (i.e. CD players) and video input sources (i.e. DVD players, cameras, etc.)
•
Your mixer
•
Finally, any amplifiers, televisions, monitors, projectors, etc.
•
10. When turning off, always reverse this operation by powering down in the following order:
Any amplifiers, televisions, monitors, projectors, etc.
•
• Your mixer.
Finally, any audio/video input sources.
•
11. Go to www.numark.com for product registration.

Rear Panel Overview

1. Power: Plug a standard IEC power cable here. Use the switch to turn the unit on and off.
2. Video 1-4 Monitor Outputs: These are pre-mix, pre-effects outputs for monitoring your video
sources. Connect to video monitors if desired.
3. Video Inputs: Composite video and S-video inputs. Connect to your video sources (DVD, VCR,
camera etc.) If your video source has an S-video output, use the S-video connector, otherwise use
the composite RCA connection.
4. Video Mixed Output: Available in composite RCA and S-video configuration, these are the main
video outputs which contain the post-mix, post-effects video signal.
connected to your main projection system or video display.
5. Audio Mixed Output: These are the main audio outputs of the mixer, and contain the post-mix
audio signal. There are two sets of outputs - the BOOTH output for DJ booth audio monitoring, and
the MASTER output which should be connected to the main P.A. system.
6. Channel 4 inputs: There are 2 sets of inputs for channel 4, a set of dedicated line-level inputs and
a set of inputs that are switchable from line-level to phono level. To use a phono level turntable
with the AVM02, make sure you connect it to the PHONO inputs and make sure the switch is set to
the PHONO position. If using a turntable that requires to be grounded, make sure that the ground
wire is connected to the silver ground terminal on top of the input panel.
7. Channel 3 inputs: Channel 3 has 2 sets of line level inputs. These inputs, marked LINE and DVD
correspond with the LINE/DVD switch located above the CH3 fader on the front panel of the mixer.
8. Channel 2 inputs: Channel 2 has 2 sets of line level inputs. These inputs, marked LINE and DVD
correspond with the LINE/DVD switch located above the CH2 fader on the front panel of the mixer.
9. Channel 1 inputs: Channel 1 has a dedicated microphone input as well as a switchable line level /
phono input. Use the switch above the channel 1 fader to choose either Line/Phono or Mic. If using
a turntable that requires to be grounded, make sure that the ground wire is connected to the silver
ground terminal on top of the input panel.
10. Balanced XLR Outputs: Use these balanced XLR outputs to connect the main output of the mixer
to an XLR equipped amplifier or input device.
11. Master Gain Reduction: An additional gain control is provided on the rear panel to limit the
maximum output level of the Master XLR output to prevent amplifier/speaker damage.
3
Normally this would be