Inserting Retaining Bars - Miele professional A 313 Instrucciones De Manejo

en - Areas of application
Inserting retaining
bars
38
The component sets for reprocessing large-volume laboratory glass-
ware include rods or supports which are used to support the items
during reprocessing. These must be secured in place with the aid of
the module's retaining bars.
The supports are matched to the shape of the items used. They must
be secured in place using the retaining bars.
The rods can be used as required and are combined with the retain-
ing bars to support the load items. Once the retaining bars have been
inserted, the distances between the rods and the locking pins must
be roughly equal to the diameter of the load items to ensure that the
items move as little as possible during reprocessing.
Place the rods and/or supports on the top of the frame.

Guide one end of the retaining bar through the relevant opening on

the frame up to the corresponding opening on the opposite side 
and push the bar through the opening.
Turn the retaining bar until the locking pins at the ends of the bar

are pointing downwards .
The rods and/or supports are now secured in place.