Connecting Battery To Power Tool; Disconnecting Battery From Power Tool - Stihl AR 900 Manual De Instrucciones

Connecting Battery to Power
Tool
A factory-new battery is not fully
charged.
Recommendation: Fully charge the
battery before using it for the first time.
If necessary, remove the cover from
N
the power tool's battery
compartment before fitting the
adapter, i.e. depress both locking
levers to unlock and remove the
cover.
Insert adapter
Insert the adapter (1) in the power
N
tool – the adapter slides into the
compartment – press it down
carefully until it snaps into position –
the adapter must be flush with the
top of the housing.
AR 900
The battery and power tool are now
connected together.
For further information on switching on
and operating the power tool: see the
instruction manual of the power tool
being operated with this battery.
Disconnecting Battery from
Power Tool
Switch off the power tool – see also
N
instruction manual of the power tool
being used.
2
1
Depress both locking levers (1) at
N
the same time to unlock the adapter.
Take the adapter (2) out of the
N
power tool.
The battery and power tool are now
disconnected.
English
1
13