Indication Of Connectors And How To Read Them - Suzuki SQ 416 2005 Manual De Instrucciones

INDICATION OF CONNECTORS AND HOW TO READ THEM

The connectors are indicated as shown below in "SYSTEM CIRCUIT DIAGRAM" section. For the shape and pin
arrangement of each connector used in this manual, refer to "LIST OF CONNECTORS" section. Described below
are how they are indicated and how to read them.
1. · The male terminal and female terminal are identified by a double enclosure and a single one respectively.
· The intermediate connector which connects harnesses is shown by both shapes of the male terminal and the female
terminal but the connector to be connected directly to the equipment is shown by the shape of the connector on the
harness side.
· The connectors described in this manual are always "harness side connectors" which are viewed from the direction as
shown at the right..
Male terminal
4 3 2 1
8 7 6 5
Female terminal
1 2 3 4
5 6
Terminal No.
2. · There are three types of connectors with respect to the way it is connected and each type is illustrated as shown
below.
· To be inserted directly into equipment
· To be connected with harness connector of equipment
· To connect between harnesses (intermediate connector)
A40
A40
D18
D18
7 8
Consult "LIST OF CONNECTOR" section
for the pin position refering to this code (D18-5).
8A-6-9HOW TO USE THIS MANUAL 8A-1-9
Terminal No.
5
B15
This indicates that they are indedntical.
2