Kobalt 0857432 Manual De Instrucciones página 30

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ASSEMBLY INSTRUCTIONS FOR ROUTER TABLE
23. Attaching the Fence Assembly to the Table
WARNING
• Always unplug the router table before attaching
accessories or making any adjustment.
a. The fence is shipped completely assembled;
loosen the three bolts and clamping knobs
before attaching it to the table.
b. Place the fence assembly on the tabletop
surface and align the three holes on the bottom
of the fence assembly with the slots on the
router table.
c.
From underneath, slide three long, round-
head, square-neck bolts through the slots on
the router table and the holes of the fence respectively. Put a plain washer onto each bolt.
Slightly tighten the clamping knobs.
d. Slide the fence along the slots on the table, then secure it to the desired location on the
tabletop surface by tightening the clamping knobs.
e. To prepare the table for transportation and storage, loosen the clamping knobs, push the
fence back and remove the fence from the table.
WARNING
• Always attach the fence to the table when you use the router table.
24. Attaching the Miter Gauge
WARNING
• Always unplug the router table before attaching
accessories or making any adjustment.
a. Attach the miter gauge (V) to the table by
placing the miter-gauge bar in the slot on the
table.
b. To adjust the miter gauge, loosen the miter
gauge knob, rotate the miter gauge to the
desired angle and tighten the knob again.
23
24
30
V

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

K11rta-0

Tabla de contenido