TECshow BEAMPIX 14 Manual De Usuario página 4

3. OPERATION INSTRUCTIONS
• The Beampix 14 is for wash effect for onsite
decoration purpose.
• Don't turn on the fixture if it's been through
sever temperature difference like after trans-
portation because it might damage the light
due to the environment changes. So make sure
to operate the fixture until it is in normal tem-
perature.
• This light should be keep away from strong shak-
ing during any transportation or movement.
• Don't expose the fixture in overheat, moisture
or environment with too much dust when
installing it. And don't lay any power cables on
the floor. Or it might cause electronic shock to
the people.
• Make sure the installation place is in good safe-
ty condition before installing the fixture.
• Make sure to put the safety chain and check
whether the screws are screwed properly when
installing the fixture.
• Make sure the lens are in good condition. It's
recommended to replace the units if there are
any damages or severe scratch.
• Make sure the fixture is operated by qualified
personnel who knows the fixture before using
• Keep the original packages id any second ship-
ment is needed.
• Don't try to change the fixtures without any in-
struction by the manufacturer or the appointed
repairing agencies.
• It is not in warranty range if there are any mal-
functions from not following the user manual to
operate or any illegal operation like shock short
circuit, electronic shock, lamp broke, etc.
P. 4
Tecshow Beampix 14 | English version