Specification; Intent Of Use; Placing Tool Specification - avdel AV 50 73435-02000 Manual De Instrucciones

Specification

Intent of Use

The AV™50 Installation Tool is principally a piston and cylinder assembly. When coupled hydraulically and electrically to
a compatible hydraulic power source and the relevant nose assembly is attached, it is then used to install 7/8" to 1 1/8"
Infalok ® in Industrial Environments.
The placing tool and hydraulic pump unit may only be used in accordance with the operating instructions for placing
®
Avdel fasteners.
Refer to the table below for the list of applicable fasteners and associated nose equipment.
Refer to the datasheets listed in the table for the relevant nose assembly instructions.
FASTENER
TYPE
INFALOK ®
Refer to the illustration on page 6 for the identification of the nose assembly dimensions 'A' and 'B'.
The safety instructions must be followed at all times.

Placing Tool Specification

Pressure:
Noise Level: Less than
Vibration: Less than
Hydraulic Oil: Enerpac
Product Range: Infalok
Additional Features:
SIZE PART NUMBER
7/8" 73410-03200
1" 73410-03100
1 1/8" 73410-03300
SPECIFICATION
Pull at stated pull pressure
Force:
Push Off at stated return pressure
Pull
Return
Stroke: Piston Stroke
Weight: Without nose equipment
® Hydraulic Oil – HF-95X
®
Stem Ejection – Front or Rear
Seal Arrangement
Hydraulic Bearing Rings
Protective Handle / Hose Gator
Protective Hose Guard
Hose / Cable Retention Clamps
NOSE ASSEMBLY
DIM. 'A' DIM. 'B'
148 mm 70 mm
152 mm 83 mm
158 mm 83 mm
METRIC
340.0 kN
140.0 kN
510 bar
200 bar
55.0 mm
13.5 kg
127 dB(A)
8.6 m/s²
22.2 to 28.6 mm
Front
Yes
Yes
Yes
NOSE ASSEMBLY
DATASHEET
PART NUMBER
07900-00919
07900-00919
07900-00919
IMPERIAL
76435.0 lbf
31473.0 lbf
7397 PSI
2901 PSI
2.17 in
29.8 lb
27.5 ft/s²
7/8 to 1-1/8 in
Lip and Wiper Seals
Yes – Front
5