DENTSPLY SmartLine Max Instrucciones De Uso página 8

The SmartLite ® Max Light is designed so that even with a low battery, the high output power indicated in the
specifications is maintained. Once the output power can no longer be sustained at that level, the SmartLite
Max Light will shut down. This way, you are assured that the SmartLite
output, regardless of the battery's condition.
To charge the battery, place the SmartLite
supply attached to the cradle, or attach the power supply directly to the handle. When this is
done, the AMBER BATTERY CHARGING INDICATOR will illuminate.
The SmartLite
even if the battery is low. While in this configuration, the battery will charge while the unit is not
being used. While charging, the GREEN BATTERY STATUS INDICATOR will illuminate. When the
battery is fully charged, the green indicator will switch off . When the handle is removed from the
charger, or the power disconnected, none of the battery indicators will illuminate.
3.6 Operation
The SmartLite ® Max Light features a "sleep" mode when not in the charging cradle or attached to the power
supply. If the unit has not been used for more than 10 minutes, the display will turn off to conserve power. If
the display is not illuminated, simply pick up or move the unit to bring it out of the sleep mode.
The curing wand has an arrow embossed on either side of the LED head for alignment with the target (Fig. 7).
Press the MODE and TIMER buttons to select the desired settings. Since the probe can be rotated 360°, it
could be used both as a wand style with thumb operation or gun style with index finger operation.
Wand Style
Always use the settings recommended by the manufacturer of the dental material when selecting the settings
for the SmartLite ® Max Light.
To position the head to the desired angle, simply rotate the head (plastic) portion of the SmartLite
The head can rotate an unlimited number of times in any direction. This helps the operator to achieve easy
access to remote areas of the oral cavity without causing unwanted discomfort or stress to the operator or the
patient.
Probe lens damage by contamination
• Prior to use, put a disposable barrier sleeve onto the probe and make sure it fits properly without
any wrinkles.
• Do not allow unprotected lens contact with restorative material.
Make sure everyone is wearing the appropriate eye protection. Once the settings are correct, position the head
of the SmartLite ® Max Light over the site to be illuminated and press the START button. Once the curing cycle
is complete, the unit will automatically turn the light off. If needed, the START button can be pressed again to
deactivate the light before the curing cycle is complete.
Be aware that the SmartLite
cycles in rapid succession occur, especially in Boost mode, the built-in temperature overload sensor
may activate, causing the Boost symbol on the SmartLite
the unit in the charging cradle or on the counter and wait at least 6 minutes before trying to use the unit again.
This protects the lifespan of the LEDs in the unit.
6
® Max Light may be used with the power supply attached to the handpiece handle,
Max Light does generate some heat when in use. If multiple curing
®
® Max Light always delivers the top light
® Max Light in the charging cradled, with the power
Fig. 7
® Max Light to flash. If this occurs, place
Gun Style
®
®
Max Light.