Commissioning; Parameter Setting; Electronic Programming Module (Epm) - Lenze ESMD251X2SFA Instrucciones De Funcionamiento

Commissioning

4 Commissioning
4.1

Parameter setting

Status/fault messages
NOTE
If the password function is enabled, the password must be entered into C00 to
access the parameters. C00 will not appear unless the password function is enabled.
Refer to C94.
4.2

Electronic programming module (EPM)

The EPM contains the controller's memory. Whenever parameter settings are changed,
the values are stored in the EPM. It can be removed, but must be installed for the
controller to operate (a missing EPM will trigger an F1 fault). The controller ships with
protective tape over the EPM that can be removed after installation.
An optional EPM Programmer (EEPM1RA) is available that allows: the controller to be programmed
without power; OEM settings to be default settings; fast copying of EPMs when multiple controllers require
identical settings. It can also store up to 60 custom parameter files for even faster controller programming.
12
Change parameters
Lenze 13435747 EDBSX03 v17 EN, DE, FR, IT, ES
smd004