Adc / 10 Aac+Dc Position; Min/Max Key; Mem / Auto Mem Key; Key - Metrix MX 24B Manual De Instrucciones

4.1.3. 10 A / 10 A
DC
4.2. MIN / MAX key
If you press this key (long press), you access the surveillance mode (or coming out), in
which minimum (MIN), maximum (MAX) and sliding average (AVG) values of the current
measurement are stored (capture time ≤ 500 ms). The signs MIN MAX AVG appear on
the display.
You can look up each of these values by repeatedly pressing the same key (short press).
The symbols MIN, MAX or AVG flicker with the selected value.
The three MIN, MAX, AVG values are stored in memory and can be read after quitting the
surveillance mode.
When you access the surveillance mode again, all previous values stored are cleared.
This key also desactivates the auto power-off, if it is pressed when switching on
(« P_OFF »).
4.3.

MEM / AUTO MEM key

Short press (MEM) : Fixes the display on the current value. A second short press returns
Long press (AUTO MEM) : Accesses or quits the "autostore" mode.
Autostore
Set the probes on the point to be measured. An audio signal indicates whether the
measurement is stable. When you remove the probes, a second audible signal indicates
that this stable value displayed has been stored.
F
The bargraph remains active during the "autostore" and display MEM mode.
Pressing this key when switching on the instrument enables the selection of a rejection of
50 or 60 Hz. The selection is reversed from the last configuration. It is displayed for 2
secs. and remains backed up in non-volatile memory.
4.4.

key

Activates/deactivates back lighting of the display unit. It automatically goes off after 30
seconds.
22
Position
AC+DC
10 A
DC current measurement
(Range 10 A
AC+DC key
10 A
AC+DC current measurement (TRMS)
(Range 10 A
AC+DC key
the multimeter to normal mode. The MEM sign appears on the display.
The MEM mode is avaible on all measurement.
The MEM sign blinking on the display.
Affected ranges : V
DC
)
DC
AC+DC
)
AC+DC
, V , V
LOW Z AC+DC DC
5000-count portable digital multimeter, with current input
Chapter II
The AC+DC sign
appears on the display.
, ADP , ADP
DC AC+DC