DeWalt DCP580 Manual De Instrucciones página 13

tool handle. Insert it into the charger as described in the charger
section of this manual.
Squeeze the tool trigger for three seconds to dissipate the slight
electric charge that may still be in the tool. The worklight may come
on for a brief moment.
FUEL GAUGE BATTERY PACKS (FIG. 4)
Some D WALT battery packs include a fuel gauge which consists of
e
three green LED lights that indicate the level of charge remaining in
the battery pack.
The fuel gauge is an indication of approximate levels of charge
remaining in the battery pack according to the following indicators:
75–100% charged
51–74% charged
< 50% charged
Pack needs to be charged
To actuate the fuel gauge, press and hold the fuel gauge button (P). A
combination of the three green LED lights will illuminate designating
the level of charge left. When the level of charge in the battery is below
the usable limit, the fuel gauge will not illuminate and the battery will
need to be recharged.
NOTE: The fuel gauge is only an indication of the charge left on the
battery pack. It does not indicate tool functionality and is subject to
variation based on product components, temperature and end-user
application.
For more information regarding fuel gauge battery packs, please call
1-800-4-D WALT (1-800-433-9258) or visit our website www.dewalt.
e
com.
FIG. 4
P
Trigger Switch (Fig. 2)
WARNING: This tool has no provision to lock the switch in the
ON position and should never be locked ON by any other means.
Release the trigger switch lock-off button (B) by pressing the button.
CAUTION: Allow the tool to reach full speed before touching tool
to the work surface. Lift the tool from the work surface before turning
the tool off.
To start the planer, depress the trigger switch (A).
To turn the planer off, release the trigger switch.
Adjusting the Planing Depth (Fig. 2)
To adjust the depth of cut, turn the planing depth adjustment knob (J).
Each click is equal to 0.1 mm of depth up to the maximum depth of
cut of approximately 5/64" (2.0 mm).
It is recom mended that test cuts be made in scrap wood after each
re-adjustment to make sure that the desired amount of wood is being
removed by the planer. Several shallow passes (rather than one deep
one) will produce a smoother finish.
11