Display Functions; Troubleshooting - Carrera RC Racing Machine 120007 Instrucciones De Montaje

Ocultar thumbs Ver también para Racing Machine 120007:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 16
3
4
5
Light on/off
ON­ / OFF­
Road
6
7

Troubleshooting

Problem
Cause
Car does not move
Either the switch on the controller or the car is set to OFF.
There is no rechargeable battery in the car or the battery is too weak.
The overheat protection has caused the car's motor to cut out due to excess
temperature.
The battery or rechargeable battery in the transmitter or model is too weak.
Car cannot be
Vehicle starts moving unintentionally.
controlled
Errors and changes excepted
Colours / final design – changes excepted
Technical changes and design-related changes excepted
Pictograms = symbolic photos
The 2.4 GHz controller is suitable for
left- or right-handers and can be
adjusted as necessary by unscrewing
and refixing the steering unit accord-
ingly.
Function can be changed by
remounting the steering unit
To remount, unsrew the three screws on
the inside of the steering unit and screw
them to the opposite side.
Remove the cover plate from the other
side and mount the steering wheel to
the opposite side. Insert and tighten the
three inner screws again. Finished!
Light on/off
Press the upper button on the controls
to switch the light on and off.
On / off­road mode
Press the middle button on the control
unit to activate the On/Offroad modes.
Can also be operated while the car is in
motion.
TH­TRIMM
Fine speed regulation
Here you can adjust the braking effect
on your vehicle.
TRIMM­steering
Fine steering adjustment
If the vehicle does not run in a straight
line, you can make fine steering adjust-
ments here.

Display functions

1
2
3
4
5
Solution
Switch on.
Insert charged battery.
Switch off the receiver.
Leave the RC car to cool down for approx. 30 minutes.
Insert new battery or recharged battery.
First turn on the transmitter, only then the vehicle.
11
Stopwatch function
When the controls are switched 'on' -
the stopwatch appears. The stopwatch
can be started and stopped by pressing
the small wheel on the display. Press-
ing the disc for a prolonged period
resets the stopwatch to zero.
Stopwatch and LAP counter function
Please note:
The control unit in the LCD screen fea-
tures a LAP counter showing the pre-
programmed starting time. Currently
these functions are not in use and are
intended for future developments.
Display of the controller battery status
on the controller display.
TH­TRIMM
Fine speed regulation
Here you can adjust the braking effect
on your vehicle.
TRIMM­steering
Fine steering adjustment
If the vehicle does not run in a straight
line, you can make fine steering adjust-
ments here.
SP (TH trim) and AL (steering trim) are
achieved by repeatedly pressing the
small wheel.

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido