DeWalt DW735 Manual De Instrucciones página 5

Specifications
Input ....................... 120 V AC '_, 15 Amp
No load speed ........ 10,000 RPM
Feed speed ............ 14 ft. per minute or 26 ft. per minute
Planing height ......... Maximum 6", Minimum 1/8"
Planing width .......... Maximum 13"
Planing depth ......... Maximum 1/8" (for boards 6" wide or less)
Electrical Connection
Be sure your power supply agrees with the nameplate marking. Volts,
50/60 Hz or "AC only" means your planer must be operated only with
alternating current and never with direct current. Voltage decrease of
more than 10% will cause loss of power and overheating. All DEWALT
tools are factory tested, if this tool does not operate, check the power
supply.
Transporting the Planer
j_ WARNING: For your own safety, it is
recommended that two people carry this
machine or serious injury could result.
When moving your planer, carry it either
by the side carrying handles (A) or by the
handles at the base of the planer (B). When
transporting or storing the planer, use the
cord wrap located in the back of the tool (C)
to keep the cord in place.
Bench Mounting
To facilitate bench mounting, two different sized holes (D) are provided
on the four corners of your planer. If mounting the planer with bolts,
use the larger holes. If mounting the planer with nails or screws, use
the smaller holes. It is not necessary to use both sets of holes.
Always mount your planer firmly to prevent movement. To enhance
the tool's portability, it can be mounted to a piece of 1/2" (12.7mm) or
thicker plywood which can then be clamped to your work support or
moved to other job sites and reclamped.
NOTE" If you elect to mount your planer onto a piece of plywood,
make sure that the mounting screws don't protrude from the bottom
of the wood. The plywood must sit flush on the work support.
_CAUTION: The mounting surface should not be warped or
otherwise uneven. -_
ASSEMBLY
E ....
_WARNING: DO NOT REMOVE GUARDS (E). Serious injury could result.
A_WARNING: To reduce the risk of serious
personal injury, turn tool off and
disconnect tool from power source before
making any adjustments or removing/
installing attachments or accessories.
TO A'rI'ACH THE DEPTH ADJUSTMENT ©
CRANK HANDLE
1. Remove the screw located in the crank
handle shaft.
2. Insert the crank handle (F) over the shaft.
3. Secure in place with the screw and
T-wrench (G) provided. B
DUST EJECTION PORTS
Your planer comes with a dust ejection port. The round port (I) as
shown below is for use with a 4" dust collector hose.
TO SET UP DUST EJECTION
1. Select the port (I).
2. Depress the lock button (K) on the chip ejection chute (H).