Attaching And Aligning The Appliance; Connecting The Pipes; Attaching Flue Duct - Gaggenau AW 230 790 Instrucciones De Uso Y Montaje

Attaching and aligning the
appliance
1 Initially remove the protective foil from the back
of the appliance and, following installation,
remove foil completely.
2 When attaching the appliance, ensure that it
engages firmly with the brackets.
3 Align the appliance horizontally by turning the
brackets. If required, the appliance can be
moved to the right or left.
4 Tighten the screws on the brackets holding the
brackets in place with one hand.
5 Screw on knurled nut and washer firmly.
«
¬
®
¯

Connecting the pipes

Note: If an aluminum pipe is used, smooth the
connection area beforehand.
Exhaust-air pipe Ø 6" (150 mm) (recommended size)
Attach exhaust-air pipe directly to the air-pipe
connector and seal.
_
Exhaust-air pipe Ø 4
1 Attach reducing connector directly to the air-
pipe connector.
2 Attach exhaust air pipe to the reducing
connector.
3 Seal both joints appropriately.

Attaching flue duct

9
WARNING
Risk of injury
From sharp edges during installation. Always
wear protective gloves while installing the
appliance.
1 Separate the flue ducts.
To do this, remove the adhesive tape.
2 Remove the protective foil from both flue ducts.
3 Push one flue duct into the other.
Notes
‒ To prevent scratches, lay paper over the
edges of the lower flue duct to protect the
surface.
‒ The slots of the inner flue duct point
downwards.
4 Place flue ducts on the appliance.
5 Push the inner flue duct upwards and attach it to
the angle brackets on the left and right.
6 Press the flue duct downwards until it
©
engages.
" (120 mm)
¨
21