Operating The Appliance; Control Panel; Remote Control; Setting The Fan - Gaggenau AC 402 Instrucciones De Uso

Operating the appliance

Note: Switch on the ceiling ventilation when you start
cooking and switch it off again a few minutes after you
have finished cooking. This is the most effective way of
removing the kitchen fumes.

Control panel

#
Switches the fan on/off
1 Switches on fan setting 1
2 Switches on fan setting 2
3 Switches on fan setting 3
Ž
Switches on intensive mode
ž
Switches on the fan run-on
œ
Resets the saturation indicator
ž
Switches on the lighting

Remote control

Except for resetting the saturation indicator, you can
operate all appliance functions using the control panel
or remote control.
#
Switches off the fan
1 Switches on fan setting 1
2 Switches on fan setting 2
3 Switches on fan setting 3
Ž
Switches on intensive mode
ž
Switches on the fan run-on
ž
Switches on the lighting
Point the remote control at the control panel.
Notes
‒ Ensure that the ceiling ventilation is not obstructed.
‒ If the appliance does not respond even when the
remote control is very close, replace the remote
control batteries.

Setting the fan

Note: Always adjust the fan strength to meet current
conditions. If there is a large build-up of steam or fumes,
select a high fan setting.
Switching on
#
1 Press the button.
The fan starts at setting 2.
2 Press the 1, 2, 3 or
corresponding fan setting.
Note: When using the remote control, you can only
switch the fan on by pressing button 1, 2, 3 or
#
the button to switch the fan off.
Switching off
#
Press the button.

Intensive setting

You can use the intensive setting if there is a large build-
up of odours and fumes/vapours.
Switching on
#
1 Press the button.
The fan starts at setting 2.
Ž
2 Press the button.
Intensive mode is activated.
Note: Intensive mode runs for six minutes. Once
this time has elapsed, the appliance switches back
to the previously selected fan setting.
Note: Using the remote control, you can switch on the
intensive setting directly by pressing the
Ž
button to set the
Ž
Ž
button.
. Press
7