Makita DUR184L Manual De Instrucciones página 9

► 1. Reverse button
NOTE: During the reverse rotation, the tool operates
only for a short period of time and then automatically
stops.
NOTE: Once the tool is stopped, the rotation returns
to regular direction when you start the tool again.
NOTE: If you tap the reverse button while the tool's
head is still rotating, the tool comes to stop and to be
ready for reverse rotation.
Nylon cutting head
Optional accessory
NOTICE:
The bump feed will not operate properly if
the head is not rotating.
► 1. Most effective cutting area
The nylon cutting head is a dual string trimmer head
provided with a bump & feed mechanism.
To feed out the nylon cord, tap the cutting head against
the ground while rotating.
NOTE: If the nylon cord does not feed out while
tapping the head, rewind/replace the nylon cord
by following the procedures described under
"Maintenance".
Adjusting the shaft length
WARNING:
Before adjusting the shaft length,
release the switch trigger and remove the battery
cartridge from the tool. Failure to release the trig-
ger and removing the battery cartridge may cause a
personal injury.
CAUTION:
sleeve before operation. Otherwise the tool may
lose control and result in personal injury.
To adjust the length of the shaft, turn the lock sleeve
counterclockwise until the arrow mark on the lock
sleeve indicates the unlock mark on the housing, and
pull out or push in the shaft to the desired length.
1
After adjustment, tighten the lock sleeve until the arrow
mark on the lock sleeve indicates the lock mark on the
housing.
1
► 1. Shaft 2. Lock sleeve
ASSEMBLY
WARNING:
switched off and battery cartridge is removed
1
before carrying out any work on the tool. Failure to
switch off and remove the battery cartridge may result
in serious personal injury from accidental start-up.
WARNING:
completely assembled. Operation of the tool in a
partially assembled state may result in serious per-
sonal injury from accidental start-up.
Installing the grip
Fit the grip onto the pipe and tighten it with the bolt and
the knob.
1
► 1. Grip 2. Bolt 3. Knob
Make sure that the grip is located in the straight area of
the shaft shown in the figure.
9 ENGLISH
Make sure to tighten the lock
2
Always be sure that the tool is
Never start the tool unless it is
2
3