Using Side Av Connectors; Using Other Connectors; Remote Control Handset; Inserting Batteries - CONTINENTAL EDISON CETVLCD40FHDR3 Manual De Instrucciones

Using Side AV Connectors

You can connect a range of optional equipment to
your LCD TV..
• For connecting a camcorder, connect to the VIDEO
IN socket and the AUDIO SOCKETS. Do not connect
the camcoder to VIDEO IN socket at the same time
since it can cause noise in the picture. For selecting
the related source, see the section "Input selection"
in the following parts.
• To listen the TV sound from headphones, connect
to the HEADPHONE jack of theTV.

Using Other Connectors

You can connect a range of optional equipment
to your LCD TV. Possible connections are shown
below. Note that cables shown in the illustration are
not supplied.
• For connecting a to a device that has SPDIF support,
use an appropriate SPDIF cable to enable sound
connection.

Remote Control Handset

Inserting Batteries

• Remove the battery cover located on the back of
the handset by gently pulling backwards from the
indicated part.
• Insert two AAA/R3 or equivalent type batteries
inside. Observe the correct polarity (+/-) when
inserting batteries and replace the battery cover.
Note: Remove the batteries from the remote control
handset when it is not to be used for a long period.
Otherwise it can be damaged due to any leakage of
batteries. Remote range is approximately 7m/23ft.

Switching On/Off

To Switch the TV On

• Connect the power cord to the 220-240V AC, 50
Hz.
• Press STANDBY touch button. Then the standby
LED lights up.
• To switch on the TV from standby mode either:
• Press the "
on the remote control.
• Press the
The TV will then switch on.
Note: If you switch on your TV via PROGRAMME
UP/DOWN buttons on the remote control or on the
TV set, the programme that you were watching last
will be reselected.
By either method the TV will switch on.
Note: When the device is coming out of standby the
light on the front of the unit will flash until the picture
appears. If you activate the power operation again
(before the light has had time to stop flashing) the
device will turn off into stndaby mode again. This is
normal operation and not a fault.

To Switch the TV Off

• Press the "
the STANDBY touch button on the TV, so the TV will
switch to standby mode.
To power down the TV completely, unplug the
•
power cord from the mains socket.
Note: When the TV is switched to standby mode,
standby LED can blink to indicate that features such
as Standby Search, Over Air Download or Timer is
active. The LED can also blink when you switch on
the TV from standby mode.

Digital Teletext (** for UK only)

• Press the "
• The digital teletext information appears.
• Operate it with the coloured buttons, cursor buttons
and OK button.
• The operation method may differ depending on the
contents of the digital teletext.
• Follow the instructions displayed on digital teletext
screen.
• When Press "
on the screen, press the OK button.
• When the "
television broadcasting.
• With digital terrestrial broadcasting (DVB-T), in
addition to digital teletext broadcasting together with
the normal broadcasting, there are also channels
with just digital teletext broadcasting.
English - 47 -
" button, P+ / P- or a numeric button
-P/CH or P/CH+ touch button on the TV.
" button on the remote control or press
" button.
OK" button or similar message appears
" button is pressed, the TV returns to