Using A Conditional Access Module; Viewing Conditional Access Menu (*); Configuring Language Preferences - CONTINENTAL EDISON CETVLCD40FHDR3 Manual De Instrucciones

Using a Conditional Access
Module
IMPORTANT: Insert or remove the CI module only
when the TV is SWITCHED OFF.
• In order to watch certain digital channels, a conditional
access module (CAM) can be necessary. This module
must be inserted in the CI slot of your TV.
• Obtain the Conditional Access Module (CAM) and
the viewing card by subscribing to a pay channel
company, then insert both into the TV using the
following procedure.
• Insert the CAM and then the viewing card to the
slot that is located in the terminal cover at the rear
side of the TV.
• The CAM should be correctly inserted, it is
impossible to insert fully if reversed. The CAM or
the TV terminal may be damaged if the CAM is
forcefully inserted.
Connect the TV to the mains supply, switch on
and then wait for few moments until the card is
activated.
• When no module is inserted, "
Interface module detected" message appears on
the screen.
• Refer to the module instruction manual for details
of the settings.

Viewing Conditional Access Menu (*)

(*) These menu settings may change depending on
the service provider.
Press "MENU" button and select the icon by using
" " or " " button. Press OK button to view Settings
menu. Use " " or " " button to highlight Conditional
Access and press OK to view menu items.
Configuring Language
Preferences
You can operate the TV's language settings using
this menu.
Press "MENU" button and select the Settings icon
by using " " or " " button. Press OK button to view
Settings menu. Use " " or " " button to highlight
Language and press OK to continue:
Use " " or " " button to set an item. Settings are
No Common
stored automatically.
Menu: displays the system language.
Preferred
These settings will be used if available. Otherwise the
current settings will be used.
• Audio
• Subtitle
language will be seen in subtitles.
• Teletext
• Guide
Current (*)
(*) These settings can be changed only if the
broadcaster supports. Otherwise, settings will not be
available to be changed.
• Audio
channel.
• Subtitle
channel.
Note: If the Country option is set to Denmark, Sweden,
Norway or Finland, the Language Settings menu will
function as described below:
English - 61 -
: Sets the preferred audio language.
: Sets the subtitle language. Selected
: Sets teletext language.
: Sets the preferred Guide language.
: Changes the audio language for the current
: Sets the subtitle language for the current