Mounting Instructions; Safety Instructions - DURAVIT DuraSystem WD1002 000 000 Instrucciones De Montaje

Important information
The mounting instructions come as part of the Duravit
product and must be read carefully prior to installation.
Target readership and qualifications
The toilet frame may only be installed by a qualified
plumber. The electrical installation should only be carried
out by qualified electricians.
Explanation of the key words and symbols
Indicates a hazardous situation which,
DANGER
if not avoided, will result in death or
serious injury.
Link to the mounting instructions in this section
Link to the Electrical installation section
Link to other instructions
Cold water
Water installation
Inspect to check for leaks and leak-tightness
> Action required

Safety instructions

Risk of fatal electric shock
Contact with electricity can lead to an electric shock.
> Carry out the electrical installation in accordance with
the national, European and international directives and
standards.
Product and/or property damage
The breach of local and country-specific regulations and
standards can cause damage to the product
and/or property damage.
> Observe the local installation regulations and any
country-specific standards at all times.
6
MAL_57154/17.10.1
Prior to the installation
> Check the load-bearing capacity of the wall.
> Please read the pre-installation data sheets. These are
available to download on the Internet at
www.pro.duravit.com.

Mounting instructions

+
13 18 Observing the position of the drain
If the height of the toilet frame is set on the
reference marker, the height of the drain is at 240
mm.
The height of the toilet frame can be adjusted
individually:
> Set the height of the toilet frame based on the
position of the drain according to the technical
drawing of the toilet.
31 Connecting the toilet frame to the ventilation
> Connect the toilet frame according to the
requirements for ventilation systems.
39
SensoWash shower toilet (optional)
®
Duravit recommends carrying out the pre-installation
when subsequently installing the shower toilet.
40
Installing the water supply for the SensoWash
shower toilet (optional)
The water supply can be provided via a fixed water
installation or subsequently via the empty pipe for the
cistern water installation.
Fixed water installation:
> Install the pre-installation set #005072 0000.
Water connection via the cistern:
> Install the connection set #100691 0000.
46
Observing the load-bearing capacity of the wall
> Please read the pre-installation data sheets.
®