Mounting Instructions - DURAVIT Blue Moon Instrucciones De Montaje

important information
Mounting instructions information
These mounting instructions come as part of the Duravit
whirltub and should be read carefully prior to installation.
Explanation of the key words and symbols
Indicates a hazardous situation which,
DangEr
if not avoided, will result in death or
serious injury.
Is used to address practices not related
noticE
to physical injury.
Link to the Electrical installation section
Link to the mounting information in this section
Inspection (e.g. for scratches)
Indication of the length of time (e.g. 10 minutes)
Inspect to check for leaks and leak­tightness
Indication of the temperature
target readership and qualifications
The whirltub must only be installed by trained plumbing
engineers. The electrical installation should only be carried
out by qualified electricians.
risk of product and/or property
noticE
damage!
> Observe the local installation regulations and any
country­specific standards at all times.
Safety instructions
DangEr
risk of fatal electric shock!
> Do NOT remove any whirltub components.
6
WH_M_BlueMoon_built­in/15.11.1

Mounting instructions

Please read pre­installation information sheets prior to
the installation. These are available to download on the
Internet at www.duravit.com.
If the tray has a base inlet, a pipe
noticE
Seitenansicht
interrupt must always be installed on­
site. (DIN EN 61770, DIN EN 1717)
> See installation diagram.
checking the whirl system (Diagram 20)
20
> Switch on the whirl system for 10 minutes:
Run this through once completely in the case of
Technische Verbesserungen und optische VerŠnderungen an den abgebildeten Produkten behalten wir uns vor.
We reserve the right to make technical improvements and enhance the appearance of the products shown.
Datum Name Ma§stab Artikel-Nr.
circuits with different levels of intensity.
Date Scale Model-No.
Gezeichnet Name
08.10.13 Allgaier 1:20
Drafted
> Leave the water in the bathtub and wait 10
GeprŸft Bezeichnung
08.10.13 WLT 1:10 X
Certified
Description
GeŠndert
1:5
minutes.
Modified
> Check to make sure that it is leak­tight.
> If adjustments are required, repeat the check.
Providing for an inspection hatch (Diagram 21)
21
Install the whirltub such that all vital assemblies
(pump, air blower and controls) remain accessible
> Providing for inspection hatches
• Dimensions of the inspection hatches
for assemblies: min. 50 x 50 cm
for drain fittings: min. 20 x 20 cm
• Sealed to avoid spray water
• Only to be opened with a tool
Providing for an air supply (Diagram 22)
22
> Provide for an opening on the panel with an area
of approx.15 cm
2
(e.g. 3 x 5 cm or 2 x 7.5 cm) for the air supply.
Lateral view
Zeichnung
000000 # W-T- 000000 - 00 - 0
Drawing
Schematische Zeichnung mit Rohrunterbrecher
Spezial Ab-und †berlaufgarnitur mit Bodenzulauf
fŸr Badewanne
Special waste and overflow with base inlet
for bathtubs