Art. 6600/AU, 660A/AU, 6700/AU
B) Microphone.
C) Loudspeaker.
D)
Pair of push-buttons.
When the interphone is not connec-
ted, the push-buttons can be used to
select the tune for calls from a
speech unit only. To programme the
tune: hold 1 of the 2 push-buttons
down for at least 2 seconds, and
press the push-buttons again repea-
tedly to select the desired tune.
E)
Pair of push-buttons
1) While holding the "I" push-button
down, press the "E" push-button to
increase or decrease the internal voice
line volume.
2) To adjust ring-tone volume:
without pressing the "E" push-but-
ton, hold down 1 of the 2 push-but-
tons for at least 2 seconds, then
press the pushbuttons again repea-
tedly to increase, decrease or disable
the ring-tone volume.
F) Push-button
auxiliary service if connected (e.g.
stair lights).
G) Push-button
release.
H) Pushbutton
auxiliary service if connected (e.g. 2nd
: for activating 1st
: for door lock
: for activating 2nd
lock). Enables the selfconnection of
interphone without being called (the
function is optional according to the
type of installation).
I)
Pushbutton:
and/or switch-on of the interphone,
hold the push-button down for con-
versation with the speech unit.
Enables the selfconnection of inter-
phone without being called (the func-
tion is optional according to the type
of installation).
L)
Door open signal: if the green
LED lights up, this indicates that the
door is open (the function is optional
according to the type of installation).
M)
Call disabled signal: if the red
LED lights up, this indicates that the
call is disabled (see point "E").
N.B.
-
Maximum operating temperature: 40°
-
Do not expose the appliance to drip-
ping, sprinklings of water and do not
put any object filled with water on it.
Do not obstruct the ventilation ope-
nings.
-
Attention: to avoid hurting oneself,
this appliance must be fixed to the
wall according to the installation
instructions.
GB
after
the
call