EYENIMAL Training Soft Manual De Instrucciones página 19

CODING PROCEDURE
1 To begin the coding procedure, the remote control must be ready for use (battery in its housing).
2 Collar in position "deactivated" (indicator light off): move the remote control towards the collar so that
the round mark on the remote control comes into contact with the white mark on the collar, hold for 6
seconds. The indicator on the collar lights in fixed green, then flashes in red.
3 Move the remote control away from the receiver collar.
4 Press the button of the remote control. A beep sound is emitted; the collar is then synchronized with
your remote control.
 Reprogram an EYENIMAL Training Soft receiver collar
The receiver collar can be re-coded indefinitely, either with the same remote control, or with a new one
(Ref. § coding procedure).
How to use the EYENIMAL Training Soft remote control

The EYENIMAL Training Soft remote control is designed to operate with 1 receiver collar.
button: beeper

If you press the "beeper" button
this function: the beeper will continue to sound for as long as the button is pressed.
The central indicator light of the remote control will come on for as long as the button is pressed.
It's up to you to use the beeper depending on the way you want to train your dog.
With the beeper you can:
- send a sound to your dog when it is disobedient,
- draw its attention...
It's very important to always use the beeper in the same way in order not to disturb your dog.
button: high luminosity LED

If you press the
approximately 8 minutes.
If you press the button again before the 8 minutes are over, you will stop the LED.
The central indicator light of the remote control will come on briefly.
 V button: short vibrations
If you press the V button, the receiver collar will emit a short vibration of approximately 1 second.
The central indicator light of the remote control will come on briefly.
, the receiver collar will emit sound signals. There is no time limit for
button, you will activate a blinking red high luminosity LED on the collar for
Gb - 19