Important Safety Precautions - Pentair intellicomm Automation Guia De Instalacion

3

IMPORTANT SAFETY PRECAUTIONS

WARNING Read and follow all safety warning notices and instructions in this manual before
installing this product. Failure to follow safety warnings and instructions can result in severe injury,
death, or property damage.
CAUTION When using the IntelliComm communication center with the IntelliFlo pump, it is
recommended to wire the IntelliComm power center to a ground fault circuit-interrupter (GFCI)
to protect the circuit. A green colored terminal (or a wire connector marked "G", "GR", "Ground"
or "Grounding") is provided within the terminal compartment in the Power Center transformer
enclosure. To reduce risk of electric shock, connect this terminal or connector to the grounding
terminal of your electric service or supply panel with a conductor equivalent in size to the circuit
conductors supplying this equipment.
WARNING To reduce the risk of injury, installation or service should only be attempted by a
qualified Pool Service Professional.
WARNING To reduce the risk of injury, do not permit children to use this product unless they
are closely supervised at all times.
CAUTION The IntelliFlo pump is for use with permanently installed pools and may also be
used with hot tubs and spas if so marked. Do not use with storable pools. A permanently installed
pool is constructed in or on the ground or in a building such that it cannot be readily disassembled
for storage. A storable pool is constructed so that it may be readily disassembled for storage and
reassembled to its original integrity.
The recommended IntelliComm Communication Center installation steps are:
1. Review Important Safety Precautions: Review this important
information.
2. Review IntelliComm Overview: Review the product overview.
3. Installing IntelliComm: Installing the IntelliComm enclosure.
4. Connecting the AC wires to IntelliComm: Connecting AC wires to
terminal 1 and 2.
5. Connecting control input wires to IntelliComm: Connecting control input
wires to terminals 3 to 10 from source devices such as automation controllers or
heaters.
• IntelliComm Communication Center
• IntelliComm Installation Guide (this manual)
• Two wire RS-485 communication cable. Used to communicate to the IntelliFlo pump
from IntelliComm.
Installation Steps Summary
Section 1
Section 2
Kit Contents