Pentair intellicomm Automation Guia De Instalacion página 6

Idiomas disponibles

Section 6

Conecting AC power wires to IntelliComm

WARNING! IMPORTANT SAFETY PRECAUTIONS. BEFORE STARTING READ

THE FOLLOWING: Read all the safety precautions in this manual before attempting

any electrical wiring. Be sure to read and follow all safety Instructions on page

ii. Wiring should only be performed by a qualified professional. When using

electrical products, basic precautions should always be followed, including the

following:

•

Grounding is required. The unit should be installed by a qualified service person and

grounded.

To connect the AC power wires to IntelliComm:

1. Connect the main AC power wires to the IntelliComm AC terminals number 1 and 2

as shown below.

2. Grounding: Attach incoming GROUND wire to the ground terminal as shown below.

Earth grounding is necessary to ensure personal safety and safety of equipment.

3. Close the front cover and tighten the two cover screws.

Ground terminal

Attach incoming AC (100 VAC to 240 VAC 50/60 Hz)

wires to AC terminals 1 and 2

Tabla de Contenido