Hkoenig V5i Manual De Instrucciones página 8

Steam ironing.
1. Fill water tank with clean tap water refer to above filling instruction. For better
performance, please immerse filter in water for several minutes before installing it into the water
tank).
2. Connect the unit into a suitable main socket. Turn temperature contrai dial to steam iraning
position, heating indicator light on iran unit lights up to indicate that the unit is being heated up.
When it turn off, the desired temperature has been reached,it is ready for steam iraning. Du ring
use,heating indicator light will cycle from ON to OFF and then OFF to ON, it indicates that the iran
is automatically heat preservation.
3. Before first time use of steam iraning, please clean the iran as below methods: Take the
iran unit up from the base unit, press steam button underneath the handle to allow steam release
for 30 seconds and then stop for 30 seconds, do so as a cycle, and repeat above cycle again.
The iran is not ready for using until the heating indicator light turns OFF.
4. During steam iraning, steam rate will be varied when temperature contrai dial is adjusted to
different positions. This can prevent water leakage caused from soleplate.
5. After using, take the iran unit back onto base unit,turn temperature contrai dail to "MIN",
and then unplug from main socket.
6. SI ide water tank out from the base unit and empty it.
Note:
a. For every first time use, it is normal thafs a slightly vibration sound may be occurred from
electrical pump inside the base unit for a few seconds when steam iraning started. lt is because
there is air inside the filter, it will stop till the air inside the filter has been pumped out. If this
abnormal conditions coutinuously happen for more than 60 seconds, please check whether water
tank and filter assembled correctly or not.
b. When temperature contrai dial is set at "synthetic" position. it only suits for dry iraning,
max steam will be obtained when set at "MAX" position, when set at "Wool" steam will be smaller
gradually.
Dry ironing
1. Connect the appliance to a suitable socket outlet.
2. Set temperature contrai dial to desired position according to iraning instructions on the
garment label or fabric setting chart. Heating indicator light (red) at iron unit lights up to indicate
the unit being heated up. When the heating indicator light turn off, the desired temperature has
been reached. During use, heating indicator light will cycle from ON to OFF and then OFF to ON.
lt indicates that the unit is heat preservation.
3. After using, take the iran unit back onto base unit, turn temperature contrai dial to "MIN",
and then unplug from main socket.
Note: When changing your Temp setting from higher setting to lower, it is proposed that not to
start iraning immediately since it may cause burns to your fabrics. Please wait till temperature
indicator light lights up steadily, and then start iraning.
Vertical steam ironing
Follow the steam ironing process, and then hold the iron in
vertical position between 5cm and 15cm away from the hanged
fabrics. Press down steam switch, this will create vertical steam.
This feature is especially used for removing creases from
hanging clothes and curtains. Never directly perform steam
ironing on people. (Fig.8)